DYNA JOURNAL ENGINEERING

Key words:

Coordinate measuring machine, structured light 3D scanner, process deformation measurement, Máquina de medir por coordenadas, escáner 3D de luz estructurada, medición de la deformación del proceso.

Article type:

ARTICULO DE INVESTIGACION / RESEARCH ARTICLE

Section:

RESEARCH ARTICLES

In this work, deformations produced during the manufacturing process of AISI D2 steel circular knives for metal slitters have been measured. For that, using a Coordinate Measuring Machine (CMM), measurements were performed at different points of both faces of 13 knives extracted from ifferent stages of the manufacturing process, including a cryogenic treatment, to analyze its influence on the generated deformations. To analyze the deformations of each knife, the following characteristics were defined for each of its two faces: the flatness, the conicity and the peak-to-peak value
and the number of undulations of several curves defined by measurements. The results obtained allowed to identify possible origins of the deformations and were analyzed to draw conclusions and try to propose improvements in the manufacturing process. Finally, as a test, a measurement was performed with a structured light 3D scanner and it was observed that with 3D scanners, measurements can be performed in much less time. However, further studies are needed to determine whether these 3D scanners are accurate enough to be used in this type of study